Smart Internet Bridge - Quick Start Guide

Created by Bever Innovations, Modified on Wed, 19 Nov at 12:24 PM by Bever Innovations

Remove the lid. Mount the enclosure to the wall.
Connect the mains cable to a suitable mains connector.
Setup internet connection:
- If a wired connection is used, feed the ethernet cable through the center gland and connect it to the ETHERNET 1 port.
- - or -
- Insert SIM card into SIM slot if a cellular connection is used. The card should have ‘microSIM’ (3FF) format. The SIM card should be activated and unlocked (no PIN code required).

Optionally: if connection to an IC(-U) or Sign Controller is required, connect the cable to the RS422 connector. Connect the other side of the cable to the IC(-U) or Sign Controller.
Turn on mains. Wait a minute for the bridge to boot up.
Open the EOS Manager app on your phone and configure the bridge if necessary. By default a wired ethernet connection is used. If a mobile connection is required, enable the ‘Use cellular’ setting first.
The status LED indicates the connection to EOSConnected:

•	Steady red	Ethernet cable disconnected.
••	Blue / Red	Cable connected but no IP lease obtained. Static network configuration required, or DHCP problems.
••	Green / Red	Connected to network, EOSConnected unreachable. Possible DNS or Firewall problems.
•	Steady green	Connected to EOSConnected.
• •	Yellow / Red	Sim card is locked
• •	Yellow/off	Sim card not found. Make sure the sim card is correctly inserted.
• •	Yellow / Blue	Sim card blocked, busy or powered down