Communicator D4i Dongle - Settings Overview

Created by Bever Innovations, Modified on Fri, 27 Oct, 2023 at 1:39 PM by Arjen Groenenberg

Basic

*Name*	*Range*	*Description*	*Default*
Base Output
Output power	[0-100]%	Default output, when in a Smart network and group and no other levels are received. Note: if device not in network or group, it will not communicate a percentage over Dali.	100%
Dali communication
Repeat DALI command	[0-20]	Amount of times DALI command should be repeated.	0
Use logarithmic output level	ON/OFF	ON: Logaritmic output (typical case for DALI), OFF: Linear output	ON

Advanced

*Name*	*Range*	*Description*	*Default*
Smart
Device network identifier	[0-30]	Smart network identifier	255 (Not set)
Dali communication
Output offset	[0-100]%	Offset the output with a given percentage, capped to 100%	0%
Use DALI Broadcast	ON/OFF	Whether to send broadcast command or use EOS to DALI mapping (See Service tab). Make sure to have this value to ON for D4i Dongle)	ON

Expert

*Name*	*Values*	*Description*	Default
External motion interpretation
Time to dim	[0-60][s,m,hrs]	Time to dim after last motion detection	2 min
Dim saving	[0-100]%	Percentage to dim after last motion detection	70 %
Use deepdim	ON/OFF	Dim even deeper	OFF
Time to deepdim	[0-60][s,m,hrs]	Time to deep-dim after last motion detection	5 min
Deep-dip saving	[0-100]%	Percentage to deep-dim after last motion detection	100 %
	External antenna
Use external antenna	ON/OFF	Whether to use the external antenna